PERCo TTR-04CW, Assembly And Operation Manual

Page: 10 / 34

TTR-04CW Electromechanical Tripod Turnstile
The RC panel is connected to the CLB with a multicore cable (6) via the “XT1.L” connector
block (Ref. Fig. 5 and 6).
If the turnstile orientation relatively to the operator’s terminal is not standard (e.g. the
terminal is placed at the backside of the turnstile housing), the RC panel orientation
towards the turnstile can be changed by exchanging places of the RC wires to the contacts
Unlock A and Unlock B as well as contacts Led A and Led B accordingly (see Fig. 5 and
Fig. 6).
5.2.5 The CLB (Fig. 5) contains:

X1 ( Control ) – connector to connect the control mechanism (connected to the “X1”
connector of the control mechanism with the turnstile cable);

XT1.L ( In ) – connector block to connect the RC panel / WRC / inputs of an ACS
controller as well as an emergency unblocking device;

XT1.H ( Out ) – connector block to connect a siren and outputs providing
the turnstile status data to the ACS controller;

XT2 ( Detector ) – connector block to connect an intrusion detector;

XT3 ( +12VDC ) – connector block to connect the turnstile power supply;

XT4 ( Light A ) and XT5 ( Light B ) – connector blocks to connect “Open/closed” light
indicators, one pair per each direction;

J1 – connector to select the turnstile control mode;

J2 – connector for programming.
Figure 5. Control Logic Board (CLB)
9