PERCo TTR-04CW, Assembly And Operation Manual

Page: 20 / 34

TTR-04CW Electromechanical Tripod Turnstile
8 INSTALLATION INSTRUCTIONS
8.1 Installation details
It is recommended:

to mount the turnstile on steady and level concrete (grade 400 or higher, strength
group V22.5), stone or similar foundations at least 150 mm thick;

to level the foundation so that the anchoring points of the turnstile lie in the same
plane (to be verified with a builder’s level);

to apply reinforcing elements (300×300×300 mm) for installation on less steady
foundation;

to organize the passage zone according Fig. 11;

to mark the mounting holes according to Fig. 12;

to control the vertical position of the turnstile during installation

to arrange additional emergency exit;

when creating the passage area through the turnstile take into account
that the resetting device operates as follows:
-
at the barrier arm turning at the angle of more than 60° the reset is effected
in the direction of movement;
-
at the barrier arm turning at the angle less than 60° the reset is effected
in the counter to the movement direction (reset to home position).
Note:
The angle gradient, at which the barrier arm reset commences, may vary in the
range of ±5°.
To ensure accurate passage tracking, when the turnstile is operated from an ACS, it is
recommended to create the passage area in such a way that the barrier arms should turn
in the direction of movement at the angle no less than 70° (Fig. 11).
Figure 11. Site preparation. Recommendations
8.2 Installation tools

1.2÷1.5 kW hammer drill;

Ø16mm hard-alloyed drill bits;

Floor chaser for electric raceway;

Cross-head screwdriver No.2;

Flat slot screwdriver No.5 (150mm);

Flat slot screwdriver No.2

Horn-type and socket wrenches S17, S13, S10, S8, S7;

Plumb line and level;
19