PERCo TTR-04CW, Assembly And Operation Manual

Page: 12 / 34

TTR-04CW Electromechanical Tripod Turnstile
Table 1. Legend to Fig. 6
Legend Item Q-ty Note
A1*, A2* Remote indicators for directions of A and B 2
A3* Remote indicator power supply 1
A4* Siren 1 12 V DC
A5* Turnstile power supply 1 12V DC, 1A
A6 CLB 1 CLB-110
A7 Control mechanism 1
A8 Indication module 1
A9* Emergency unblocking device (Fire Alarm) 1
A10* Intrusion detector 1 CLIP-4
A11 RC panel 1 H6/4
A12* Wireless remote control kit 1 MSRF-4
A13* Access control system 1
A14 Heating system controller 1
A15 Heating unit 1
A16* Heating system power supply 1 24V AC, 2.5A
1 Turnstile cable 1
2
Wire jumper. Installed when the emergency unblocking device
(A9) is not connected
1
Installed on
default
* Available upon request
5.3 Control over the turnstile
5.3.1 The turnstile can be operated from the following control devices:

the RC panel;

the WRC;

the ACS controller.
The above devices can be connected to the turnstile as follows:

any device separately;

in any combination with each other;

all devices simultaneously (in parallel).
Note:
At the parallel connection of the above devices to the turnstile the superposition
of the control signals from them may occur. In that case the turnstile response will
conform to response to the obtained combination of input signals (Appendices A
and B).
5.3.2 Connection of the devices stated in Clause 5.3.1 is made with the cable (11) to the
corresponding connector blocks
XT1.L or XT1.H of the CLB in accordance with the
connection layout (Fig. 5 and 6).
5.3.3 The RC panel is connected to the contacts GND, Unlock A , Stop , Unlock B , Led A ,
Led Stop and Led B of the XT1.L connector block.
5.3.4 The WRC kit is connected to the contacts GND, Unlock A, Stop and Unlock B of the
XT1. L connector block. Power supply of the WRC is connected to the contact +12V of the
XT1.H connector block.
5.3.5 The ACS controller outputs are connected to the contacts GND , Unlock A , Stop and
Unlock B of the XT1.L connector block.
11