CP302
CMOS Setup
ID 21112, Rev. 05
Page 4 - 32
®
PEP Modular Computers GmbH
EISA Configuration Is Not Complete - Please Run EISA Configuration Utility
The slot configuration information stored in the EISA non-volatile memory is incomplete.
Error Encountered Initializing Hard-Drive
Hard drive cannot be initialized. Make sure that the adapter is installed correctly and that
all cables are correctly and firmly attached. Ensure also that the correct hard drive type
is selected in “Setup”.
Error Initializing Hard-Disk Controller
Cannot initialize controller. Make sure that the cord is correctly and firmly installed in the
bus. Ensure also that the correct hard drive type is selected in Setup. Also check to see
if any jumper needs to be set correctly on the hard drive.
Floppy-Disk Controller Error or No Controller Present
Cannot find or initialize the floppy drive controller. Make sure that the controller is
installed correctly and firmly. If there are no floppy drives installed, ensure that the
floppy-disk drive selection in “Setup” is set to
NONE
.
Invalid EISA Configuration - Please Run EISA Configuration Utility
The non-volatile memory containing EISA configuration information was programmed
incorrectly or has become corrupted. Re-run EISA configuration utility to correctly
program the memory.
Keyboard Error or No Keyboard Present
Cannot initialize the keyboard. Make sure that the keyboard is attached correctly and
that no keys are being pressed during the boot process.
If you are deliberately configuring the system without a keyboard, set the “Error Halt”
condition in “Setup” to
HALT ON ALL, BUT KEYBOARD
. This causes the BIOS to
ignore the missing keyboard and continue the boot process.
Memory Address Error at ...
Indicates a memory address error at a specific location. You can use this location along
with the memory map for your system to find and replace the bad memory chips.
$
$
Note:
When either of the above EISA error messages appears, the
system boots in ISA mode so that you can run the EISA
Configuration Utility.
$
$
Note:
When this error appears, the system boots in ISA mode so that
you can run the EISA configuration utility.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
