CP302
Installation
ID 21112, Rev. 05
Page 3 - 4
®
PEP Modular Computers GmbH
3.1.1
Placement of the CP302
The PEP CompactPCI system configuration is characterized by the fact that its system
slot (slot “1”) is on the right end of the backplane, thus allowing for physical CPU growth
(heat-sink, cooling fan etc.) associated with higher-performance processors.
3.1.2
EIDE Interfaces.
The CP302 board is provided with two EIDE interfaces, a primary onboard and a
secondary on the Rear I/O.
The EIDE interfaces each allow installation of up to two devices (one master-slave pair).
If installed, the devices are automatically recognized by the BIOS at system “power on”.
Hard-Disk Installation
To install a HardDisk, it is necessary to perform the following operations in the given
order:
1.
Install the hardware;
2.
Initialize the software necessary to run the chosen operating system.
$
$
Important!
After having inserted your controller board, please make sure it
has been fitted into the system slot.
$
$
Important!
The primary EIDE interface supports a maximum of two devices
connected in the master-slave mode. To configure the first as a
master disk and the second as a slave disk please refer to the
HardDisk manufacturer’s documentation.
!
Attention!
The incorrect connection of power or data cables may damage
your HardDisk unit and/or CP302 board.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
