ULTRATEMP
®
Heat Pump Installation and User’s Guide
18
ULTRATEMP
®
Heat Pump Installation and User’s Guide
Temperature Scale - C˚ or F˚
The control board can display temperatures in either
degrees Fahrenheit or Celsius. The temperature scale
in use can be changed from the Operator Setup Menu
Tree as described below:
1. Press the UP and DOWN arrows simultaneously.
The Language Selection screen should be dis-
played.
2. Then press the MENU SELECT button repeatedly
until the Temperature Scale screen is displayed.
3. Press the UP or DOWN arrows to toggle between
the Fahrenheit and Celsius options. The last option
shown on the display will become active.
Water Temperature Offset
The control board provides the ability to increase or
decrease the measured water temperature by 2 degrees.
To change the temperature offset:
1. Press the UP and DOWN arrows simultaneously.
2. Press the MENU SELECT button repeatedly until
the Temperature Offset screen is displayed.
3. Press the UP or DOWN arrows to select the
desired offset. The last number shown on the
display will become active.
TEMPERATURE SCALE
FAHRENHEIT / CELSIUS
TEMP OFFSET
OFFSET = -2 TO +2
Defrost Cycle
The UltraTemp
®
Heat Pump may enter a defrost cycle
if air temperatures are around 50° F (10° C).
The defrost cycle initiates when the evaporator sensor
detects refrigerant temperature below the defrost set
point. At this time, the heat pump compressor stops.
The heat pump evaporator fan will continue to run,
and will draw air over the evaporator fins for about 15
minutes.
If the temperature sensor detects a temperature above
44° F (7° C), the compressor will restart after the 15
minutes. If not, the unit will shut down.
The efficiency of a heat pump decreases as air
temperature decreases. For maximum efficiency,
operate the heat pump during the warmest time of day.
Heat Pump
Control Panel
Locking the Control Panel
1. Heat pump control panel lock-out – To prevent
unwanted adjusting or manipulating of the heat pump
settings, the control panel can be locked. Once locked,
if any button is pressed, the display will read:
•
To activate the control panel lockout, press
the MENU SELECT and POOL/SPA buttons
simultaneously.
•
To unlock the control panel, press the MENU
SELECT and POOL/SPA buttons simultaneously.
HEAT PUMP
CONTROLS LOCKED