11
IntelliFlo
®
Pump Demo Kiosk Operation and Set-Up Instructions
IntelliFlo
®
Pump Demo Kiosk Operation and Set-Up Instructions
Purging the Pressure Sensing Hoses
(If pressure sensor box is installed)
1. Disconnect the high pressure (RED) tube to vent air out of line (use lower pump speed while bleeding the line).
2. Disconnect the low pressure (BLUE) tube, allowing air to flow though tube until dry (about 15 seconds).
Computer Program Operation
The computer shipped with this Kiosk Demo Unit has pre-installed software. To be sure you have the most updated
software version, a flash drive with a software update may be included. The software
version is listed in the bottom right corner of the program start up window. Follow the instructions below to install the
software update, if applicable.
First uninstall the current version (to be sure you have latest software update):
1. Click the ‘Start’ menu (lower right corner of tool bar) and click ‘Control Panel’.
2. Select ‘Programs and Features’.
3. Select “Pentair Pump Data Acquisition System” and click ‘Uninstall’ to unistall the previous version.
To install and run the updated the program software:
1. Insert the flash drive into the laptop USB port.
2. Open the flash drive file from ‘My Computer’.
3. Open file “DAQ Set Up (Version number)”
4. Follow the on-screen instructions to successfully install and run the program.
5. Open the “Pentair Pump Data Acquisition System” file to begin.
Using the Program
1. Open the “Pentair Pump Data Acquisition System” by clicking the Pentair icon on the desktop.
2. The “3 Meter Screen” (shown below) appears. To show screen options, move the mouse to the bottom of the
screen. Click on the tabs to navigate the various screen options.
Move mouse here
to show tabs
