Cerberus ADSL2+ Wi-Fi (P 6331-5)
51
Protocol
– The selections are TCP, UDP, ICMP, Specify, and none. If you choose Specify,
you need to enter the protocol number in the box next to the Protocol field. This field cannot be
configured alone, additional fields like IP, Source MAC, and/or Ingress Interface should be
configured. This field is also required if the source port or destination port has been entered.
Source Port
– The source protocol port. You cannot configure this field without entering the
protocol first.
Destination Port
– The destination protocol port or port range. You cannot configure this field
without entering the protocol first.
Source MAC
– The MAC address of the traffic source.
Local Routing Mark
– This field is enabled only when Locally Generated is selected in the
Ingress Interface field. The mark for DNS traffic generated by different applications are
described below:
•
Dynamic DNS: 0xE1
•
Dynamic Proxy: 0xE2
•
Web Server: 0xE3
•
MSNTP: 0xE4
•
DHCP Server: 0xE5
•
IP tables Utility: 0xE6
•
PPP Deamon: 0xE7
•
IP Route: 0xE8
•
ATM Library: 0xE9
•
NET Tools: 0xEA
•
RIP: 0xEB
•
RIP v2: 0xEC
•
UPNP: 0xEE
•
Busybox Utility: 0xEF
•
Configuration Manager: 0xF0
•
DropBear Utility: 0xF1
•
Voice: 0
Currently routing algorithms make decision based on destination address, i.e. only Destination
IP address and subnet mask is supported. The Policy Routing page enables you to route
packets on the basis of various fields in the packet.
The following fields can be configured for Policy Routing:
•
Destination IP address/mask
•
Source IP address/mask
•
Source MAC address
•
Protocol (TCP, UDP, ICMP, etc)
•
Source port
•
Destination port
•
Incoming interface
•
DSCP
Summary of Contents for Cerberus ADSL2+ Lite
Page 4: ......
