12
PUTTING THE TOOL INTO SERVICE
IN CASE OF TROUBLE
- Press and hold trigger 2 down. Hook 22 closes.
-
Insert the material through hole 5, while holding trigger 2 down with your finger, and push on the material
until it stops.
- Release the trigger, the hook opens and pulls the material. If the material is not pulled by the hook,
repeat the previous operations.
- Check that no piece of material remains inside the twister by making a test tie and remove the material.
INSERTION OF THE MATERIAL INSIDE THE TOOL
In order to prevent any risk of the tie being jammed in the tyer, we recommend that you check that there
are no pieces of tie stuck in the front part of the tyer, any time that you miss a tie.
In the event of jamming, the tyer locks and stops.
In this case:
-
Set switch 11 to the “0” off position.
- Cut the tie at the entry aperture 5.
- Unclip the detachable spout 1 and take it off, sliding it forwards.
- Take off upper guid 20.
-
Set switch 11 to the “1” on position.
- Perform several cycles, pressing on trigger 2, until the whole tie comes out of the top of the device.
- Check that there are no small pieces of tie remaining jammed in the tyer in the interior, or in the front
part.
- Replace the upper guide 20, and the detachable spout 1.
- Reintroduce the tie into the tyer, as described above.
