Peg-Perego Viaggio 2-3 Flex Surefix, Instructions For Use Manual, Page: 25 / 162

19
How to attach the car seat
to the vehicle
if you own a car with no
Isofix attachments
15
• Position the Viaggio 2-3 Flex
car seat on the vehicle seat in the
direction of travel, leaving the
attachments inside the Surefix Base
(fig_a) and position the child in the
seat as shown in the figure (fig_b),
ensuring the car seat does not move
during this operation.
How to secure your child
with Viaggio 2-3 Flex
16
• Secure your child with the vehicle
seat belt as shown in the figure.
17
• Fasten the vehicle seat belt,
ensuring that it clicks in place.
Position the two sections of the belt
as shown in the figure.
18
• To finish securing your child,
thread the belt through the router
placed on the headrest: thread the
belt between the router and the
headrest (1) until it slides into the
router slot (2).
IMPORTANT: If the belt is
loose, pull it taut above the loop
(3). Ensure the belt is always
tensioned and untwisted.
19
• To remove the belt, slide it out of
the router slot (1) and then between
the router and the headrest (2) until
it is completely removed.
20
•
IMPORTANT:
the seat belt
is correctly positioned if the child’s
shoulders are slightly below the seat
belt loop, as shown in the figure.
How to remove the
fabric lining
The fabric elements of Viaggio 2-3
Flex may be removed for cleaning.
21
• Follow the washing instructions
on the seat's lining.
REMOVING THE LINING FROM
THE SEAT:
22
• Unhook the two eyelets from
the buttons on the sides of the car
seat base.
23
• Release the two hooks from the
seat base.
24
• Remove the lining and slide
out the plastic panel placed inside
the pocket as shown. Remember to
replace it once the lining has been
washed
REMOVING THE LINING FROM
THE BACKREST:
25
• Remove the four eyelets from the
plastic buttons on the sides of the
backrest. To facilitate this operation,
widen the side wings
26
• Release the two upper elastics
and the two lower ones located on
each side.
27
• Remove the two flaps from
their slots on the upper part of the
backrest. To facilitate this operation,
raise the headrest. At this point you
can remove the lining from the car
seat's backrest.