Peco 56651201, Operator'S Manual, Page: 50 / 54

50
DOCUMENT THE FOLLOWING INFORMATION FOR FUTURE REFERENCE
Unit Model Number:_______________________________________________
Unit Engine Size:__________________________________________________
Unit Serial Number:________________________________________________
Date of purchase:________/________/_________
Dealer/Distributor Name:__________________________________________
Address: _________________________________ State:_______ Zip:_______
Phone Number: ____________________________________________________
New PECO, Inc.
10 Walden Dr | Arden, North Carolina 28704
Phone: 1-800-438-5823 | 828-684-1234
Fax: 828-684-0858
Email: peco@lawnvac.com
Website: www.lawnvac.com
2019 (v1.0)
3. Make sure all shields are in place and in good
condition. Repair or replace any missing or damaged
shields.
4. Perform lubrication per instructions.
5. Listen for abnormal sounds, which might indicate
loose parts, damaged bearings, or other damage.
Correct any deficiency before continuing operation.
6. With the engine off, engage the blower assembly.
Check the belt tension and inspect the pulley belt for
cracks or tears.
7. Check for wear or deterioration of the upper or lower
hoses. If there are any portions of the hose that have
been torn or worn through, replace immediately.
After Each Use:
1. Clean all debris from machine especially from the
container, underneath the belt shields, and safety
decals. Replace any missing or illegible decals.
2. Inspect the unit for worn or damaged components.
Repair or replace before the next use. Any
replacement component installed during repair shall
include the component’s current safety decal specified
by the manufacturers to be affixed to the component.
3. Under normal usage, the collection unit is subject to
deterioration and wear. Inspect the unit for worn or
damaged components. Repair or replace before the
next use. Any replacement component installed during
repair shall include the component’s current safety
decal specified by the manufacturers to be affixed to
the component.
4. Check belt for proper tension.
Lubrication
Gearbox:
NOTE: The gearbox is filled with 6.0 oz. of Mobilube
HD Plus 80W-90 oil and permanently sealed. There is no
need for scheduled lubrication. The oil level should only
be checked if a leak is observed or if a change in
gearbox noise is noticed.
Operators are recommended to check for leaks weekly,
if a leak is observed, both the gasket and the seals are
recommended to be replaced.
Replace the oil using 5.5 oz. of the recommended
Mobilube HD Plus 80W-90 oil. Be sure to not overfill.
Blower Assembly:
NOTE: The following is for older PTO models that
contain a greaseable zerk fitting. Newer models
contain maintenance-free bearings and are without
a greasable fitting.
.
1. On initial use: Grease the fitting on the blower shaft.
2. Every 25 hours of use: Re-grease the grease fitting.
NOTE:
Use only white lithium based grease for
lubrication of the shaft on the blower assembly.
SECTION V - PARTS & SERVICE
Parts And Service Information
Collection system owners should record the name and
telephone number of their Service Center. Your Service
Center will be happy to supply replacement parts,
accessories, and do any service or repairs to your
collection system. If for any reason your Service Center
is unable to service your collection system or supply
replacement parts, contact New PECO, Inc. and include
the following information on the chart below.