Peco 56651201, Operator'S Manual, Page: 21 / 54

21
Aluminum Box Assembly Installation
NOTE: It is recommended that two extra people assist
in mounting the Box Assembly.
Two can lower the Box onto the frame while the third
person inserts the Pivot Pins P#(K0172) through the
holes. Insert the Pins from the outside to the inside.
Secure with (1) 5/8” Washer P#(K0058) and (1) 5/32” x
2-5/8” Hair Pin Clip P#(K0088) per Pivot Pin (Figure B).
Reattach the bottom ends of the door opening linkages
to the Main Frame by using (1) Rue-Ring Cotter Pin
P#(K1437) per side. To test the functionality of the dump
mechanism, pull the Lift Handle away from the unit, and
lift upward. The Door of the Box Assembly should open
and the Box should pivot clockwise towards the ground.
Dump Mechanism Adjustment
The mechanism may be adjusted in three places, at the
Adjusting Screw P#(K1435), at the Latch Hook Pivot Bolt
and the linkage Ball Joint. To change the door closure
tightness, thread the Adjusting Screw (Figure C) in or out
or by adjusting the Latch Hook Pivot Bolt within its’
mounting slot. To adjust the Latch Hook closure angle,
thread the Linkage Ball Joint in or out.
Rue-Ring
Cotter Pin
Adjusting
Screw
Washer
Hair Pin
Clip
Pivot
Pin
Box Assembly
Figure A
Figure B
Figure C
Attach
Here