Peco 56651201, Operator'S Manual, Page: 16 / 54

16
NOTE:
After Installing The Mount Arm / Tube Assembly tighten ALL hardware including
the hardware that were left relatively loose at the beginning of the installation.
Mount Arm / Tube Assembly
Installation
The set of bolt holes designated with a ‘2’ are used to
position and secure the Mount Arm / Tube Assembly
(Item #1) for the RT & SRT Mower models. Refer to
Figure B.
Before installing the Mount Arm / Tube Assembly (Item
#1), install a Stop Bolt by placing (1) 3/8”-16 x 3-1/2”
HHCS (Item #2) through both the Top Bracket and
Bottom Bracket Mount Arm. Then secure the bolt by
using (1) 3/8”-16 Ny-Flange Lock Nut (Item #3). Refer to
Figure A and Figure B.
Place the Mount Arm / Tube Assembly (Item #1)
between the Top Bracket and Bottom Bracket. Make
sure the back of the Mount Arm / Tube is resting against
the stop bolt previously installed. Position the Mount Arm
/ Tube Assembly between the (4) bolt holes and position
(4) 3/8”-16 x 3-1/2” HHCS (Item #2) through both
Brackets to better position the Mount Arm / Tube
Assembly.
Secure the (4) 3/8”-16 x 3-1/2” HHCS by using (4) 3/8”-
16 Ny-flange Lock Nuts (Item #3). Refer to Figure A.
Note: Some parts and part features have been hidden
from view for visual clarity.
Figure A
Figure B