Peco 56651201, Operator'S Manual, Page: 30 / 54

30
Weight Kit Installation
NOTE: This Assembly Installation is intended for the Right Caster of the mower. Repeat for the Left Caster.
Position the Dual Weight Bracket Base (Item#1) under the caster tubing w/ opening towards caster fork. Next, position
the Weight Bracket Clamp (Item#2) on top of caster tubing w/ opening towards caster fork.
Align the (4) holes of the Weight Bracket Clamp (Item#2) to the holes in the Dual Weight Bracket Base (Item#1).
Loosely fasten the Weight Bracket Clamp (Item#2) to the Weight Bracket Base (Item#1) using (4) 5/16"-18 x 3" Bolts
(Item#4) & (4) 5/16"-18 Ny-Flange Lock Nuts (Item#5).
Position the Weight Bracket Base and the Weight Bracket Clamp assembly along the caster tubing to prevent
interference from caster forks or any other objects. Tighten the fasteners in an 'X’ pattern until assembly is firmly
clamped to caster tubing. Do not over tighten which may result in bending Weight Bracket Clamps (Item#3).
To Install the Weights, insert (1) Weight (Item#3) Into the Weight Bracket Base (Item#2) & align the holes of the
Weight w/ the holes of the Weight Bracket Base (Item#2). Fasten the Weight (Item#1) to the Weight Bracket Base
Using (1) Clevis Pin (Item#6) & (1) Hair Pin Clip (Item#7) per weight. Repeat for additional Weights.
Refer to the Figure Below.
1
2
5
3
4
6
7
Figure A
Item # Part # Desc. Qty.
1 B1014 Dual Weight Bracket / Base 1
2 B1015 Weight Bracket / Clamp 1
3 Y0025 28 lb. Suitcase Weight 2
4 K1472 HHCS 5/16"-18 x 3" GR5 4
5 K2516 Ny-Flange Lock Nut 5/16"-18 4
6 K1473 Clevis Pin 1/2" x 3" 2
7 K1478 Hair Pin Cotter / Double Loop 2