Peco 56651201, Operator'S Manual, Page: 27 / 54

27
Wire Harness Installation (Continued)
Next, route the ( #2 ) Negative Lead (-) and the Positive Lead (+) of the Wire Harness P#(P0298) to the negative &
positive terminal of the mower’s battery. Refer to Figure B for the Wire Harness components, refer to Figure C on the
next page for the Wire Harness to mower connection.
Route the Wire Harness back towards the engine and disconnect the mower’s clutch connector and ( #3 ) interconnect
it with the Wire Harness’ Clutch Connection Jumper. Refer to Figure C. Be sure to identify and pick the correct Jumper
depending on your mower’s clutch connection type. Refer to the Wiring Diagram on Page 24 for the Connection
Jumper Types.
Figure C
Figure D
Note: To avoid damage to the Wire Harness,
do not leave any slack that will allow the Wire
Harness to come into contact with the PTO Belt
Finally, route the Wire Harness back towards the rear of the mower positioning the Wire Harness under the Bottom
Bracket / Mount Arm. Then connect the Wire Harness to the PTO Unit. Refer to Figure D.
Note : It is recommended to secure the Wire Harness to the mower by using the included Cable Ties P#(J0245) once
you have the Wire Harness installed. Be sure the Wire Harness is routed so that it does not obstruct the seat as it is
being lowered down or any part of the mower that may damage the Harness.
(#3) Be sure to check your Clutch
Connector Jumper matches the
Mower’s ClutchConnection
(#2) Negative Lead (-) to Negative Terminal
Positive Lead (+) to Positive Terminal