Peco 56651201, Operator'S Manual, Page: 26 / 54

26
Wire Harness Installation
Before installing the PTO Switch Plate, install the PTO
Rocker Switch P#(P0293) by positioning it over the
Switch Plate and firmly pressing the Rocker Switch down
until it is seated in place.
Be sure the ‘FAN’ Symbol is positioned to the ‘ON’ side
of the PTO Switch Plate. Refer to Figure A.
Once installed, connect the Wire Harness’ (2) Female
Switch Disconnects to the PTO Rocker Switch
P#(P0293). Refer to Figure B for the Wire Harness
components.
WARNING
!
To Prevent Serious Injury-
Proper Installation Of Safety Interlock Harness
Is Mandatory. Please Check That All Interlock
Points Work Correctly Once Installed.
Figure A
To install the PTO Switch Plate P#(B2038), ( #1 ) remove
the corner screw securing the control panel cover and
set it aside.
Next, ( #2 ) lift the control panel and ( #3 ) place the PTO
Switch Plate under the control panel. ( #4 ) Align the slot
with the corner mount hole and secure the Switch Plate
by using the previously removed hardware.
Refer to Figure A below.
Figure B
Negative Lead (-) to
Negative Terminal (-)
Positive Lead (+) to
Positive Terminal (+)
(2) Female Switch Disconnects
to PTO Rocker Switch
Install Rocker Switch
to Switch Plate