Pearson OpScan iNSIGHT 70, Installation Manual

Page: 35 / 48

Installation of Host Computer and Peripherals
Network Installation
3-9
Networking Equipment
OpScan i NSIGHT 70 scanners may be integrated into networking configurations
consisting of third-party equipment.
The appropriate vendor personnel are responsible for unpacking, setting up,
configuring, and testing the networking equipment. Pearson NCS field engineers
are responsible for positioning the networking equipment in accordance to the
system and network layout plans. These plans should be made available by the
site preparation project manager.
Once the OpScan
i NSIGHT 70 scanner has been installed and the networking
equipment has been positioned, you can now connect the scanner to the network
cable. Before connecting the cable to the system, verify the following:
•
The scanner is positioned in the appropriate location.
•
The network cable is installed.
•
The OpScan i NSIGHT 70 scanner and peripherals are turned off.
•
The cable is in good condition. It should not be crimped, have damaged
insulation, and it should not be placed near heat sources, power cables, or
high traffic areas without adequate protection.
Connecting a Scanner to a Network
1.
Locate the network cable for the scanner. A network connector (10BaseT,
10Base2, or Token Ring) should be attached to the network cable and located
near each scanner (if more than one).
2.
Attach the network connector (10BaseT, 10Base2, or Token Ring) to the jack
labeled NETWORK located on the scanner's back panel (bottom and second
cutout from the left).
3.
Repeat steps 1 and 2 for each additional scanner.
4.
Connect the other end of each network cable (from each scanner) to the
network concentrator.
5.
Locate and attach the cable from the concentrator to the connector jack located
on the back of the file server.