Pearson OpScan iNSIGHT 70, Installation Manual

Page: 34 / 48

Installation of Host Computer and Peripherals
Network Installation
3-8
Installation Guide for the OpScan iNSIGHT 70 Scanner
8.
Complete installation of one 9-pin D cable from the Scanner Controller main
board to the
Com1
port on the back of the computer.
•
One end of this cable is already attached to the scanner's Scanner
Controller
main board at J9.
•
Connect the other end to the Com1 port on the back of the computer.
Once all computer cabling has been made, set the computer on the shelf, coil any
extra cabling under the computer shelf, and close the rear panels.
Monitor and Keyboard
Place the monitor on top of the scanner on the right-hand side (See Figure 3-3).
Install the keyboard using the four pressure sensitive adhesive backed velcro
pads that were shipped with the keyboard. Peel off the paper backing on one side
of the pads and affix to the four corners of the keyboard. Peel off the paper
backing from the other side and affix the keyboard to the angled shelf on the
upper left-hand side of the scanner. Place the mouse and mouse pad on the flat
surface just to the right of the keyboard (See Figure 3-3).
To cable the monitor and the keyboard to the computer, do the following:
Cabling the Monitor
1.
Attach the power cord.
•
Plug the female end of the power cord into the back of the monitor.
•
Plug the male end into a nearby AC power outlet or a power strip.
2.
Ensure the monitor cable is properly connected. (Refer to Step 7, "Cabling.")
3.
Complete 5 BNC cable install from the bulkhead to the back of the monitor.
•
Connect one end of this cable to the bulkhead. Install the cable according
to the colors labeled on the bulkhead.
•
Connect the other end (15-pin) to the back of the monitor.
Cabling the Keyboard and Mouse
1.
Plug the keyboard cable into the port labeled
KEYBOARD
located behind the
angled panel next to the keyboard.
2.
Plug the mouse cable into the port labeled
MOUSE
located behind the angled
panel next to the keyboard.