Pearson OpScan iNSIGHT 70, Installation Manual

Page: 33 / 48

Installation of Host Computer and Peripherals
Network Installation
3-7
Cabling
In preparation for cabling, Pearson NCS recommends that you do the following:
•
Set the computer on the back lip of the shelf during cable installation so
that the back of the computer is tilted up. This provides easier access to the
computer's ports.
•
Uncoil all cords and cables, separate them, and lay them out on the floor.
The following cabling instructions are for a network configuration. Refer to
Figure 3-3, Figure 3-4, Figure 3-5, and Table 3-1.
1.
Install the computer power cord.
•
Attach the power cord connector to the back of the computer.
•
Ensure that the other end is plugged into the scanner's power strip.
2.
Complete installation of the 25-pin straight through cable from the
PRTCON
board (for the optional printer) to the back of the computer.
•
One end of this cable is already attached to the
PRTCON
board.
•
Connect the other end to the back of the computer.
3.
Complete installation of the network cable (10BaseT, 10Base2, or Token Ring)
from the
NETCON
board (for the network) to the back of the computer.
•
One end of this cable is already attached to the NETCON board.
•
Connect the other end to the back of the computer.
4.
Complete installation of one 6-pin DIN cable from the
KEMCON
board (for the
keyboard) to the back of the computer.
•
One end of this cable is already attached to the
KEMCON
board.
• Connect the other end to the back of the computer in the keyboard port.
5.
Complete installation of the other 6-pin DIN cable from the KEMCON board
(for the mouse) to the back of the computer.
•
One end of this cable is already attached to the KEMCON board.
•
Connect the other end to the back of the computer in the mouse port.
6.
Complete installation of the 5 BNC/15-pin DIN cable from the bulkhead (for
the monitor) to the back of the computer.
•
One end (5 BNC end) is already attached to the bulkhead.
•
Connect the other end (15-pin DIN) to the back of the computer.
Caution: Connect this cable to the 15-pin connector on the video card in the first
expansion slot. Do not connect the cable to the 15-pint connector on the system board.
7.
Complete installation of the 50-pin high density ribbon cable from the Camera
Controller
board to the
Hobbes
interface connector on the computer.
•
One end of this cable is already connected to the scanner's Camera
Controller
board at J1.
•
Connect the other end to the external connector for the scanner interface
(
Hobbes
) card (P2) on the computer.