PCE Health and Fitness PCE-ND10, User Manual

Page: 29 / 50

31
After starting eCon’s software COM port, baudrate,
transmission mode and adress should be set. It can be done in
Options. Then, PCE-ND10 meter should be selected from
Device. Push icon Load to read and save current settings.
Open window Updater – from Updating->Updating of devices
rmware. Push Connect. Update progress is shown in
Messages section. Text Port opened appear after correctly
opened port. Putting meter in update’s mode can be done in
two ways: remote from Updater (with settings from eCon –
port, baudrate, transmission mode and adress) or by turning
power on while button pressed. Meter display shows
the „boot” inscription with bootloader version, Updater shows
message „Device found” with name and current version of
firmware. Using button browse to the meter upgrade file.
If the file is opened correctly, a File opened message is
displayed. Press the Send button. When upgrade is
successfully completed, meter reverts to the default settings
and begins normal operation while the information window
displays Done message and upgrade elapsed time. Close
Updater and go to Restoration of default parameters. Select
checkbox and press Apply button. After the Updater window is
closed, press the Save icon to save all initially read
parameters. Current firmware version can be checked when
meter is power on.
Warning! Turning the meter off during upgrade process may
result in permanent damage!