ip set interface
93
Model 3231 CLI Reference Guide
8 • IP Commands
ip set interface
Configure specific settings for an IP interface.
Note
Begin each top-level command in the table below with
ip set interface <name>
.
Table 69. ip set interface <name>
Command
Explanation
dhcp
disabled
The interface does not use DHCP client information.
enabled
The interface obtains its configuration information from
the DHCP client.
ipaddress
<ipaddress>
Set the IP address for the existing IP interface.
<ipaddress> <netmask>
Set the netmask address of the interface.
mtu
<mtu>
Set the MTU (Maximum Transmission Unit) for an existing
IP interface.
netmask
<netmask>
Set the netmask for an existing IP interface.
rip
accept
all
Set the interface to accept RIP version 1 and RIP version 2
messages.
none
The interface does not accept RIP messages.
v1
Set the interface to accept only RIP version 1 messages.
v2
Set the interface to accept only RIP version 2 messages.
multicast
disabled
Disable RIP version 2 messages from being sent via multi-
cast.
enabled
Allow RIP version 2 messages to be sent via multicast.
send
all
Send RIP version 1 and RIP version 2 messages from the
interface.
none
The interface does not accept RIP messages.
v1
Send only RIP version 1 messages from the interface.
v2
Send only RIP version 2 messages from the interface.
tcpmssclamp disabled
The IP stack will not examine or modify TCP traffic routed
through the interface.
enabled
Examine and modify TCP SYN packets that are routed
through the interface.