ppp set transport
110
Model 3231 CLI Reference Guide
11 • PPP Commands
ppp set transport
Configure properties for a PPPoH transport.
Note
Begin each top-level command in the table below with
ppp set transport <name>
.
Table 82. ppp set transport
Command
Explanation
dialin
Set an existing PPPoH transport to accept dialin
connections.
dialout
Set a PPPoH transport to perform dialout.
disabled
Disable a PPPoH transport.
discoverdns
primary
disabled
Disable whether the primary DNS server address
is requested from a remote PPP peer using IPCP.
enabled
Request a primary DNS server IP address.
secondary
disabled
Disable whether the secondary DNS server
address is requested from a remote PPP peer
using IPCP.
enabled
Request a secondary DNS server IP address.
enabled
Enable a PPPoH transport.
givedns
client
disabled
IPCP cannot request a DNS server IP address
and then give the address to the DNS client.
enabled
Allow IPCP to request a DNS server IP address
and then give the address to the DNS client.
relay
disabled
IPCP cannot request a DNS server IP address
and then give the address to DNS relay.
enabled
Allow IPCP to request a DNS server IP address
and then give the address to DNS relay.
headers
hdlc
disabled
Do not allow packets that have HDLC headers to
be transmitted/received.
enabled
Allow packets that have HDLC headers to be
transmitted/received.
llc
disabled
Do not allow packets that have LLC headers to be
transmitted/received.
enabled
Allow packets that have LLC headers to be trans-
mitted/received.
interface
<iface>
Set the PPP interface for an existing transport.
lcpechoevery
<lcpechoevery>
Tell a specified PPP transport to send an LCP (Link
Control Protocol) echo request frame at specified
intervals (in seconds).
lcpmaxconf
<lcpmaxconf>
Set the LCP maximum configure number for an
existing transport.