pppoa set transport
120
Model 3231 CLI Reference Guide
12 • PPPoA Commands
qosclass
abr
Set quality of service class as abr (Available Bit
Rate) for the transport.
cbr
Set quality of service class as cbr (Constant Bit
Rate) for the transport.
qfc
Set quality of service class as qfc for the trans-
port.
ubr
Set quality of service class as ubr (Unspecified Bit
Rate) for the transport.
vbr
Set quality of service class as vbr (Variable Bit
Rate) for the transport.
vbrrt
Set quality of service class as vbrrt (Variable Bit
Rate Real-Time) for the transport.
remotedns
<ipaddress> <ipaddress2>
Set the primary and secondary local DNS server
addresses that will be given to a remote PPP peer
when the peer requests a primary or secondary
DNS server IP address usig IPCP.
remoteip
<ipaddress>
Set the IP address supplied to the remote end of
the PPP connection during negotiation.
routemask
<mask>
Set the subnet mask used by the route that is cre-
ated when a PPP link comes up.
scr
<scr>
Set scr (Sustainable Cell Rate); Valid only if you
set VBR or VBRRT as the qosclass; Applies only to
existing PVC transports.
specificroute disabled
Create a default route to the subnet at the remote
end of the PPP link.
enabled
Allow the created route to apply to packets for
the subnet at the remote end of the PPP link.
subnetmask <mask>
Set the subnet mask used for the local IP interface
connected to the PPP transport.
theylogin
chap
Set CHAP (Challenge Handshake Authentication
Protocol) for the authentication method remote
PPP clients must use to dialin to the server.
none
No authentication method is used.
pap
Set PAP (Password Authentication Protocol) for
the authentication method remote PPP clients
must use to dialin to the server.
username
<username>
Set a dial-out username on a named transport.
vci
<vci>
Set the Virtual Circuit Identifier (Applies only to
existing PVC transports).
vpi
<vpi>
Set the Virtual Path Identifier (Applies only to
existing PVC transports).
Table 88. pppoa set transport
Command
Explanation