Using a browser to complete Model 3096RC configuration
44
Model 3096RC T-DAC Getting Started Guide
3 • Configuring the T-DAC for operation
configuration before committing it to storage in FLASH. When you select
Record Current Configuration
,
the 3096RC stores your changes to FLASH memory.
Note
If you want to save the configuration changes that you have made,
you must click on
Record Current Configuration
, otherwise all con-
figuration changes will be lost if the power to the Model 3096RC is
turned off.
•
Hard Reset
—this button (see
figure 23
) causes the Model 3096RC to perform a cold restart. When you
select
Hard Reset
, the T-DAC confirms that you want to execute this command. Then, the T-DAC will dis-
connect all current sessions, re-initialize the interfaces, and re-load configuration parameters from FLASH.
•
Set Factory Default Configuration
—this button (see
figure 23
) clears out the configuration in FLASH and
loads the factory default parameters into FLASH memory. The factory default settings will not execute on
the Model 3096RC until it is re-booted by doing a Hard Reset.
Note
Set Factory Default Configuration
(
figure 23
) will delete any routing
information, the Model 3096RC’s Ethernet IP address, and any other
site-specific settings made for your particular installation. You will
have to re-enter the Model 3096RC’s Ethernet IP address and net-
mask using the rear panel control port before using the
HTTP/HTML Management pages.
Configuring the default gateway
The default gateway IP address, if defined, is used solely for managing the 3096RC remotely via the Ethernet
port. The 3096RC does not transmit or receive user data nor any other traffic via the default gateway IP
address or the Ethernet port.
Do the following to add the default gateway:
1. On the 3096RC Configuration Menu, click the IP hyperlink to open the
IP Configuration
page.
