Cable installation
29
Model 3096RC T-DAC Getting Started Guide
2 • Hardware installation
Connecting to the T1/E1 WAN ports
An active T1/E1 is not necessary to configure the T-DAC. However, an active T1/E1 connection is required when
mapping G.SHDSL modems to specific time slots in the T1/E1 ports or even for mapping WAN time slots to
other WAN time slots. The factory-set default configuration of the Model 3096RC has the T1/E1 ports disabled.
Note
The cable connecting the T1/E1 WAN ports to the RJ-48C termina-
tion jack should be CAT-3 or higher and extend no farther than
1 mile (1.6 km) from the digital services termination.
Figure 10. WAN cable‘s 68-pin SCSI connector
1. Connect the 68-pin SCSI connector (
figure 10
) of the 6-foot WAN cable (
figure 11
) to the connector on
the rear panel of the Model 3096RC
Figure 11. 68 pin SCSI-to-RJ45 6-foot WAN cable
68
34
AMP 749621-7 (or equivalent)
35
Pin 1
