Patlite WIO-B1T, Instruction Manual

Page: 42 / 88

Wireless Control Unit
42
7. Operation
7.10. Mounting
7.10.1 Direct Mounting
The mounting method for the transmitter and receiver are the same.
❶❽
❺❻
❷ ❼
* Maximum board
thickness: 7mm
Hexagon Nut
with Flange (M4)
Terminal Block
Connector
Wire
Distribution
Hole
Mounting
Hole
Direct Mount Bracket
WIO Body Unit
Indicator
Head Cover
❹
❸
The top case
and bottom case
cannot be
removed from
the indicator
Mounting Dimensions
■
Mounting Hole
(
ȭ
5 x 3 places)
ȭ
120°
Nameplate Location
Product Front
Product
Outer
Dimension
(
ȭ
60)
Wire
Distribution
Hole (
ȭ
20)
120°
(Unit: mm)
In the mounting location, drill holes for mounting
and wiring the product.
❶
Rotate the WIO body unit counterclockwise
and detach from the direct mount bracket.
❷
Use the hexagon nut with flange to secure the
direct mount bracket in the mounting position.
❸
Pass the cable through the wire distribution hole.
❹
Remove the two screws from the terminal block
connector and perform the wiring.
❺
Attach the terminal block connector to the
WIO body unit.
❻
Install the WIO body unit to the direct mount
bracket following the removal procedure in
reverse order.
❼
If required, apply sealant around the mounting
and wire distribution holes.
❽
• Detach the bracket in the same way as the head
cover described in "7.13. How to Attach and Detach
Additional Units" (
☞
page 73).
• Refer to "7.13. How to Attach and Detach Additional
Units" (
☞
page 73)
• Attach the bracket in the same way as the head
cover described in "7.13. How to Attach and Detach
Additional Units" ( ☞ page 73).
• Refer to "7.11.1. Detaching the Terminal Block
Connector" (
☞
page 46)
• Refer to "7.11.3. Wiring the Terminal Block
Connector" (
☞
page 47)
Recommended Torque
(approximate)
0.6 N ・ m