Patlite WIO-B1T, Instruction Manual

Page: 35 / 88

Wireless Control Unit
34 35
7. Operation
7.7.2. When Using Repeaters from Temporary Installation
• When using repeaters from when installation was performed, turn on the power from the transmitter, in turn,
and pair as follows.
• For products that are not paired, turn off the power.
WIO WIO WIO
Transmitter Repeater Repeater
WIO
Repeater
WIO
Receiver
Paring 2
Paring 3
Paring 4
Paring 1
7.7.3. Adding a Repeater After Temporary Installation
• If wireless quality is poor after temporary installation, consider installing a repeater. At that time, if the indicator
light is amber, the repeater can be added simply by turning the repeater ON.
• A repeater can be added between products by simply turning on the repeater only when all of the following
conditions,
①
through
③
, are met.
①
Connection information (pairing information) between products is registered.
②
The wireless connection between the products is not in good condition (indicator light is amber) (Refer to "7.8.
Checking the Indicator" (
☞
page 37))
③ The number of repeaters within a single group does not exceed 2 units.
Transmitter
Add a repeater
WIO
WIO
WIO
Repeater / Receiver
Transmitter Repeater / Receiver Repeater
Wireless
quality is
good
Wireless
quality is
good
Wireless quality is poor
Green light on
WIO
Amber light on Amber light on
WIO
Green light on Green light on
CAUTION
Add repeaters one at a time. Adding two or more repeaters at the
same time may cause connection problems.
When eliminating the installation of a repeater after the addition
of a repeater, unpair the transmitter and receiver, and pair
again. Turning off the repeater does not restore the connection
environment prior to the addition of the repeater.
A repeater may be unintentionally paired with products when
product systems exist under the following conditions. Please use
caution.
・ There are products (indicator light is amber) in close proximity
that do not have a good wireless connection between products
・ Products that are in the middle of pairing are in close proximity
Point
●
Connect via the added repeater.
●
Add one repeater between the paired transmitter and receiver/repeater,
or between the paired repeater and receiver/repeater.
● When the indicator light is amber, the repeater can be connected
regardless of whether its group ID is a match or mismatch.