Wireless Control Unit
36
37
7. Operation
7.8. Checking the Indicator
Check the indicator status with its lighting.
Transmitter
Repeater
Repeater
Repeater
Receiver
WIO
WIO
WIO
WIO
WIO
Category
Products
Indicator
Light Status
Status
Contents
Transmitter
Repeater
Receiver
Starting up
●
●
●
Lemon light on
Starting up After turning ON the power, in the start up state.
Pairing
●
●
-
Flashing blue
Pairing
After turning ON the power, in the state where the
connection information (pairing information) is not
registered.
Searching for a connection point.
-
●
●
Blue light on
Operation
●
●
●
Green light on
Wireless
quality
Wireless quality is good.
●
●
●
Amber light on
Wireless quality is poor.
Reconsider the installation location or install a
repeater.
●
●
●
Red light on
Waiting for wireless connection.
Registration of connection information (pairing
information) has completed.
●
●
●
Pink light on
Wireless connection to the destination is
established, but wireless connections between
other products in the system are not established.
Registration of connection information (pairing
information) has completed.
●
-
-
Flashing green
Flashing amber
Flashing pink
Operation
Status
Flashes when the contact detects an input.
(flashes green when the wireless quality is good,
amber when it is poor, and pink when the wireless
connection to the destination is established but not
between other products in the system)
-
●
●
Flashing green
Flashing amber
Flashing pink
Flashes when a contact is output.
(flashes green when the wireless quality is good,
amber when it is poor, and pink when the wireless
connection to the destination is established but not
between other products in the system)
●
-
-
Light blue light on
When the input detected by the transmitter
reaches the receiver, it lights up light blue for
about 1 second (answerback).
In order to periodically check the communication,
it may light up in light blue even if it is not an
answerback.
●
●
●
Alternating
Red↔ Green
Operating in unpairing mode.
Alarm
●
●
●
Flashing red
Error
Status
When a fourth repeater is attempted to be added
in the system, the indicator of the repeater flashes
red.
If the flashing status continues, an error has
occurred in the product.
