GEA RM1
31
Description of the systems interface in standalone mode
After having confirmed or changed the arrangement of the electrodes, the operator must
execute the "Continue" command and confirm that he wants to carry out the automatic
measurements.
At this point the system will proceed with the execution of the entire sequence of the
measures envisaged for the session, one after the other. During each individual
measurement, the trend of the measuring cycles and the measured sigma value will be
displayed, as described in section
. When the maximum sigma value
requested is reached, or when the configured maximum number of cycles is reached, the
measurement will end and the main measured parameters will be presented on video for
a few seconds. Then, and without the operator's intervention, the next measurement will
be performed, and so on until all the planned measures are performed.
The operator can interrupt the sequence of automatic measurements by pressing the Esc
button during the execution of a measurement.
A session of automatic measurements interrupted prematurely can be completed at a later
time simply by choosing from the menus to perform the measurements (see paragraph
Viewing the parameters of an automatic session
), in this case the values you measured
up to that point will be maintained and the automatic execution will be resumed starting
from the first missing measure.
Last session
The command allows you to directly open the last session on which you worked,
facilitating the recovery of a temporarily interrupted job. The system will go to the
F
IGURE
24
-
SELECTION
OF
THE
ORDER
OF
THE
ELECTRODES
Summary of Contents for GEA RM1 1.0
