20
7.
Description
of
the
systems
interface in standalone mode
The Gea RM1 system can be used in standalone mode or controlled by a PC.
-
Standalone mode: the Gea RM1 system is controlled by the operator using the
buttons located on the systems control panel, the information is shown on the
panel display.
-
Controlled by the PC (PC controlled mode): the Gea RM1 system must be
connected via USB cable to a computer with a Windows operating system on
which the Gea RM1-PC program has been installed and launched. All operations
available in standalone mode are available in PC controlled mode, controlled by
the keyboard and displayed on the PC screen. Further functionalities for the
preparation of campaigns measurements and the visualization of the results
obtained are offered by the Gea RM1-PC program.
In this chapter we will describe how the Gea RM1 system should be used in standalone
mode. The system is considered correctly powered and functioning, and with all the
hardware connections necessary for its use, as described in chapter 4.
Switching on the system and control panel
Figure 1 shows the front panel of the system, reference will be made in the document.
The control buttons operate in accordance to the information submitted on the system
display and perform the following functions.
-
Button (Up): moves the selected line on the display to the line above.
-
Button (Down): moves the selected line on the display to the line below.
Summary of Contents for GEA RM1 1.0
