TITLE : RP-300/310
Page -48 -
[Name]
Set relative print position
[Format]
ASCII
ESC
＼
n
L
n
H
Hex
1B
5C
n
L
n
H
Decimal 27
92
n
L
n
H
[Range]
0≤
n
L
≤ 255
0≤
n
H
≤ 255
[Description]
Sets the print starting position based on the current position by using the
horizontal or vertical motion unit.
·This command sets the distance from the current position to [(
n
L
+ n
H x
256
) x
(horizontal or vertical unit)].
[Details]
·Any setting that exceeds the printable area is ignored.
·When pitch
N is specified to the right :
n
L
+
n
H x
256
=
N
When pitch
n is specified to the left (the negative direction), use the
complement of 65536.
When pitch
n is specified to the left : n
L
+
n
H x
256
=
65536 –
n.
·The print starting position moves from the current position to [
n x
horizontal or vertical motion unit].
·The horizontal and vertical motion units are specified by GS P.
·The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal
movement amount,
and it must be in even units of the minimum horizontal movement
amount.
·In standard mode, the horizontal motion unit is used.
·In page mode, the horizontal or vertical motion unit differs as follows,
depending on the starting point of the printing area :
①When the starting position is set to the upper left or lower right of the
printable area using ESC T, the horizontal motion unit (
x) is used.
②When the starting position is set to the upper right or lower left of the
printable area using ESC T, the vertical motion unit (
y) is used.
[Reference]
ESC $, GS P
ESC a
n