890SD Standalone Drive
5-10
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames E & F
8
9
10
11
A
B
C
D
1
2
3
4
6
7
E
890SD Frame F : Duct Kit
Duct kit, Part Number LA466717U003.
The installation diagram is provided on the following page.
Caution
Protect any equipment in the cubicle from swarf etc.
Ensure all equipment is isolated.
♦
The duct length determines the vertical position of the drive in the cubicle. Drill the lower mounting
panel hole centres for the drive at 976mm from the top of the cubicle. There is a generous tolerance of
±
4mm.
♦
Cut-out the hole for the duct directly above where the drive sits. Project the position of the drive
mounting surface inside the cubicle and mark it on the roof. From the drawing, you can calculate that the
cut-out is made 8.5mm in front of the drive mounting surface (the centres for the cowling fixing holes
will be 7.5mm behind the drive mounting surface). Draw the cut-out shape, check its position, and cut it
out.
♦
Because of the weight of the drive, it may be better to secure the drive in the cubicle first, and lower the
duct into the cubicle from above.
♦
Fix the duct to the drive using the M4 fasteners.
♦
Fit the gasket between the duct cowling and the top of the cubicle to provide a good seal. Drill through
and secure all this with the M6 fasteners.