5-2
The Keypad
650G AC Drive
Display Indications
Drive Status Indications
The keypad can display the following status information:
Display
Status Indication and Meaning
Possible Cause
READY/HEALTHY No alarms
present. Remote mode selected
PASSWORD Current password
must be entered before this
parameter may be altered.
Enter password to change the
parameter. Refer to page 5-7
LOCAL Local Control selected,
healthy, no alarms present
Added or removed from the
display letter-by-letter to indicate
entering or leaving Local Control
STOP Coast Stop or Prog Stop
active
Jog (6901 op station only) or
Run pressed while Coast Stop or
Prog Stop lines are active, (low),
on the sequencing block. Local
control only.
RUN Not possible to change
between Local/Remote mode
The drive is running in Local
mode or the Remote run signal is
active
JOG Not possible to change
between Local/Remote mode
The Remote jog signal is active
ENABLE Pressed RUN or JOG
key in Local mode while Enable
signal is low
The drive Enable signal is
inactive, (low)
Quick Application Selection
You can navigate immediately to the
APPLICATION parameter,
P
1, from power-up, as
shown opposite.
Then, press the
key to display the current
Application. Press again to allow the parameter to be changed.
Use the
keys to select the appropriate Application by number.
Press the
key to load the Application.
Refer to Chapter 12: "Applications" for further information.
Hold down the key opposite:
Power-up the drive, continue
to hold for at least 1 second
HOLD
Represents a rotating shaft:
clockwise = drive running forward
anticlockwise = drive running in reverse
Displays the units for the value:
S
for time in seconds,
A
for current in Amps
V
for voltage in Volts,
%
for percentage
Hz
for frequency in Hertz
Indicates the drive is in Local control.
Drive is in remote control when not visible.
when in the Parameter menu
when in the Setup menu
when displaying an Alarm code
a negative parameter value
perating mode.
de if not visible.
rive is running in
Indicates control
via fieldbus
communications
Indicates parameter numbers or values,
trip information, error codes etc.
See "Drive Status Indications" below.
Indicates the
Control Mode
g
