8799-A2-GB20-10
April 2003
v
About This Guide
Document Purpose and Intended Audience
This guide contains information needed to set up, configure, and operate the
8-port Hotwire 8799 Time Division Multiplexer Symmetric High-bit-rate Digital
Subscriber Line (TDM SHDSL) Line Card with G.703 Interface, and is intended for
installers and operators.
Features described require firmware release 02.03.42 or above.
Document Summary
Section
Description
Chapter 1,
About the Hotwire
8799 Line Card
Describes the Hotwire 8799 Line Card’s features and
capabilities.
Chapter 2,
Using the
Asynchronous Terminal Interface
Provides instructions for accessing the user interface
and navigating the screens.
Chapter 3,
Initial Startup and
Configuration
Provides procedures for setting up the user interface
and configuring the card.
Chapter 4,
Monitoring the Card
Describes using the LEDs, status, and network
statistics to monitor the unit.
Chapter 5,
Testing
Provides information about available tests and test
setup.
Chapter 6,
Messages and
Troubleshooting
Provides information on SNMP traps, device
messages, and troubleshooting.
Appendix A,
Configuration
Options
Contains all configuration options, default settings,
and possible settings.
Appendix B,
Standards
Compliance for SNMP Traps
Contains SNMP trap compliance information.
Appendix C,
Cross-Connecting
Ports
Provides information worksheets for
cross-connecting ports.
Appendix D,
Connector Pin
Assignments
Contains connector and interface information.
