4. Monitoring the Card
8799-A2-GB20-10
April 2003
4-3
Health and Status Messages
The following messages appear in the first column of the System and Test Status
screen. The highest priority Health and Status message also appears on all ATI
screens on the bottom right.
Table 4-1.
Health and Status Messages (1 of 4)
Message
What Message Indicates
What To Do
AIS at G.703, Pt
n
An Alarm Indication Signal
(AIS) is being received by the
G.703 interface.
1. Verify that the card’s line
framing and line coding are
compatible with the attached
equipment.
2. Contact network provider.
Backup IBMC
Down
Ports configured for both the
primary and backup inband
management channels are
down.
Troubleshoot ports used for
in-band management.
Device Failed
yyyyyyyy
An internal error has been
detected by the operating
software.
yyyyyyyy indicates
the 8-digit hexadecimal failure
code.
1. Provide the 8-digit failure code
shown (
yyyyyyyy) to your
service representative.
2. Reset the card to clear the
condition and message.
DLCI
nnnn Down,
IBMC
The DLCI is down for the
Inband Management Channel.
1. Verify DLCI and LMI on the
router.
2. Verify the G.703 connection.
Download Failed
A firmware download was
interrupted.
Repeat the download.
DSL Attenuation
Thresh, Pt
n
Loop attenuation reached or
exceeded the configured
threshold within a 15-minute
interval.
1. Disable the trap by setting it
to 0.
2. Reconfigure the card to a
higher DSL Attenuation
Threshold.
3. Contact network provide to
troubleshoot the line.
DSL CRC
Threshold, Pt
n
The number of counted CRC
anomalies for the DSL
interface has reached or
exceeded the configured
threshold within a 15-minute
interval.
1. Disable the trap by setting it
to 0.
2. Reconfigure the card to a
higher DSL CRC Threshold.
3. Contact network provider to
troubleshoot the line.
DSL ES Threshold,
Pt
n
The number of errored
seconds for the DSL interface
has reached or exceeded the
configured threshold within a
15-minute interval.
1. Disable the trap by setting it
to 0.
2. Reconfigure the card to a
higher DSL ES Threshold.
3. Contact network provider to
troubleshoot the line.
