Paradyne ACCULINK 3160, Operator'S Manual

Page: 93 / 296

Operation
3-59
3160-A2-GB21-80 March 1999
Initiating a Call for PC, ASCII Terminal/Printer, or SNMP Operation
Use the Dial command to set up a semipermanent connection to route alarm
messages to the specified destination. The Dial command initiates a call through
the integral modem to a printer, ASCII terminal, or PC.
Procedure
To initiate a call at the local DSU/CSU:
1. From the top-level menu screen, press the key until the Ctrl selection
appears on the screen.
2. Select Ctrl.
3. From the Control screen, select Call.
F1
Control:
Call
Rel LED
F2
F3
4. From the Call Setup screen, select Dial. This selection is not available if the
DSU/CSU’s integral modem is already in use.
F1
Call Setup:
Pass
Dial ChDir
F2
F3
5. From the Dial Directory screen, press F1 (Up) to display the next higher
numbered directory or press F2 (Down) to select the next lower numbered
directory.
F1
Dial
n: xxxxxxxxx
Up Down Dial
F2 F3
6. When the number of the desired directory appears on the screen, press F3
(Dial) to place the call.
F1
Dial
n: xxxxxxxxx
Up Down Dial
F2 F3