Paradyne ACCULINK 3150, Operator'S Manual, Page: 29 / 234

3150-A2-GB24-10 March 2001
3-1
3
Using the Front Panel
Overview
This chapter shows how to use:
„
The standalone CSU front panel and 3000 Series Carrier control panel to:
— Display unit identity
— Reset the CSU
„
The front panel LEDs to:
— Monitor the status of the CSU
— Monitor the status of the network
— Monitor the status of the DTE
NOTE:
Additional information for the carrier-mounted CSU is located in the
ACCULINK 3151 CSU and 3161 DSU/CSU General Information Guide
and
the COMSPHERE 3000 Series Carrier Installation Manual .
Front Panel
The standalone CSU front panel ( Figure 3-1, Standalone CSU Front Panel )
consists of an LCD, a keypad, test jacks, and 12 LEDs. The carrier-mounted CSU
faceplate contains test jacks and 12 LEDs, however, the LCD and keypad are
located on the Shared Diagnostic Control Panel (SDCP) of the 3000 Series
Carrier. For more information about the SDCP, refer to the
COMSPHERE 3000
Series Carrier Installation Manual .
NOTE:
You can display a graphical representation of the CSU front panel on an
attached PC (see
Appendix H, Front Panel Emulation ).