Paradyne ACCULINK 3150, Operator'S Manual, Page: 181 / 234

F. SNMP MIB Objects
3150-A2-GB24-10 March 2001
F-13
Near End Group – “dsx1SendCode” Object (dsx1ConfigEntry 7)
This object specifies the test patterns/codes being sent over the network interface.
These tests are not supported on the DTE interface. Only the following values are
supported by the CSU.
„
dsx1SendNoCode(1) – Specifies that the interface is sending normal or
looped data. Setting the interface to this value stops an active “send pattern”
test on the interface. This is the only value supported by the DTE interface.
„
dsx1SendLineCode(2) – Specifies that the network interface is sending a
Remote Loopback (Rlpbk) LLBUP code. The code is sent for 10 seconds.
„
dsx1SendResetCode(4) – Specifies that the network interface is sending
Remote Loopback (Rlpbk) LLBDN code. The code is sent for 10 seconds.
„
dsx1SendQRS(5) – Specifies that the network interface is sending a QRSS
test pattern. The pattern is sent until the test is halted (i.e., setting to
dsx1SendNoCode).
„
dsx1SendOtherTestPattern(8) – Specifies that the network interface is sending
a 1-in-8 test pattern. The pattern is sent until the test is halted (i.e., setting to
dsx1SendNoCode).
Near End Group – “dsx1CircuitIdentifier” Object (dsx1ConfigEntry 8)
This object is only supported on the Net T1 Interface.
Near End Group – “dsx1LoopbackConfig” Object (dsx1ConfigEntry 9)
This object specifies the loopback state of the T1 interfaces. Only the following
values are supported by the CSU.
„
dsx1NoLoop(1) – The T1 interface is not in a loopback state.
„
dsx1PayloadLoop(2) – Specifies that a Payload Loopback (PLB) is active for
the network interface or a Repeater Loopback (RLB) is active for the DTE
interface.
„
dsx1LineLoop(3) – Specifies that a Line Loopback (LLB) is active for the
network interface or a DTE Loopback (DLB) is active for the DTE interface.