Paradyne 3166 CSU, User Manual

Page: 53 / 207

SDCP Operation
3-27
3166-A2-GB20-20 March 1999
Configuring SNMP Traps
A trap is an unsolicited message that is sent from the DSU/CSU to an SNMP
manager when the DSU/CSU detects certain pre-specified conditions. These
traps enable the SNMP manager to monitor the state of the network.
The SNMP Trap configuration option must be enabled for trap messages to be
sent over the communications link. You must specify the number of SNMP
managers that are to receive traps from this DSU/CSU, an IP address for each
SNMP manager specified, and the type of traps to be sent from this DSU/CSU.
For more information, refer to Appendix C,
Configuration Options , and SNMP
Traps in Chapter 4, Monitoring and Testing.
Enabling SNMP Trap Messages
Procedure
To enable SNMP trap messages from this DSU/CSU:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the key until the Alarm selection appears on
the screen.
5. Select Alarm.
F1
Edit:
User
Alarm Mgmt
F2 F3
6. Press F1 (Next) until the SNMP Trap configuration option appears.
7. Press F2 (Enab) to enable trap messages over the SNMP management link.
F1
SNMP Trap:
Next
Enab Disab
F2 F3