June 2022
17
VeriSafe 2.0 AVT
Maintenance
WARNING:
The battery powered indicator module contains a lithium battery that is a fire, explosion and severe burn hazard . Do
not
crush, recharge, disassemble or heat above 85°C (185°F), incinerate, or expose contents to water .
The AVT will not work with a standard alkaline 1 .5 V AA battery . Use only Panduit approved battery .
Battery, system cable, o-rings and gaskets can be replaced . No other part of the product is serviceable .
Do
not attempt to open the indicator module or isolation module for repair or modification . When servicing this product,
only use specified replacement parts .
The o-rings and gaskets can be replaced if they become dry or brittle . In critical sealing applications, such as wash down
environments, it is recommended that the o-rings and gaskets be replaced every 5 years . Apply a light coating of silicone
grease to the o-rings to promote sealing and extend o-ring life .
VISUAL INSPECTION
Periodically inspect the AVT and replace any damaged parts, cables or terminations .
Inspect the sensor lead terminations to ensure they are tight, the leads are secure, and does not show signs of damage .
Inspect the system cable to ensure it is locked into place on both ends, is secure and does not show signs of damage .
Inspect the indicator module to ensure o-rings or gaskets are not dry or brittle .
Inspect the indicator module to ensure the retention nut is tight and cap is firmly in place .
CLEANING INSTRUCTIONS
The indicator module can be cleaned with a damp cloth or isopropyl alcohol based cleaner . Do
not
use abrasives or high alka-
line cleaners . Do
not leave cleaners on the device for a long period, rinse immediately . Do
not apply cleaners in direct sunlight
or elevated temperatures .
Before a wash down operation, ensure the o-rings and gaskets are in good condition, the faceplate is not damaged and fully
secured to the unit, and the cap is fully installed .
BATTERY REPLACEMENT
Follow the steps below to replace the battery . The table below provides the list of batteries approved for use with the
AVT . Do
not discard the battery in the trash; take it to an appropriate battery recycling facility .
Panduit Part No.
Manufacturer
Mfr. Model No.
Size
Description
Operating Temperature
VS-AVT-BATTERY
Titus
ER14505M
ER14505
3 .6 Volt
Lithium Battery -25°C to 60°C (-13°F to 140°F)
1.
Twist the
indicator module
cap coun-
terclockwise
approximately
90 degrees, until
you feel a stop .
2.
Grip the battery
tray and slide it
out until you feel a
stop . The battery
tray is not intended
to be fully re-
moved .
3.
Remove used
battery . Install a
new battery . En-
sure the battery is
fully seated before
proceeding .
4.
Slide the battery tray
back in the housing .
A self test is initiated
when the battery
tray is inserted and
connection is made
between the battery
and AVT electronics .
5.
Replace the cap .
Twist cap clockwise
to lock into place .
6.
Record the date the battery was replaced in equipment documentation .
