June 2022
13
VeriSafe 2.0 AVT
INDICATOR MODULE AND INSTRUCTION LABEL
NOTE:
The Instruction Label is UL approved for application to galvanized and stainless steel, ABS, polycarbonate, and polyester paint-
ed surfaces . It is up to the installer to verify proper bond to other surface types .
+
-
Cap
Indicator
Module
Body
Gasket
Battery
Instruction Label
Panel Nut
SYSTEM CABLE
1.
Insert the end of the system cable with the right-angle connector in the back of the indicator module . Press firmly into the open-
ing until you feel it latch . Pull back on the connector to verify that it has properly latched .
2.
Insert the keyed-end of the system cable into the isolation module port labeled INDICATOR . System cable for an additional indica-
tor (optional) may be inserted into the isolation module port labeled AUX .
The system cable must be separated from the sensor leads and other circuits in the
electrical enclosure by a minimum of 0 .25 inches (6 mm) .
The maximum allowable system cable length for the INDICATOR port is 30 ft (9 .1m) .
The maximum allowable system cable length for AUX port is 500 ft (152m) .
If the system cable is routed outside of the enclosure that contains the isolation mod-
ule, the system cable must be installed in a conduit . When installed in conduit, the
system cable should be regarded as a data cable and must not use the same conduit as
the electrical power conductors .
Battery Powered
Battery Free
BATTERY POWERED INDICATOR MODULE
1.
Tighten the panel nut until both it and the
gasket make full contact with the enclosure
surface . Then, tighten an additional 1/4 turn .
2.
Install battery into battery tray . The positive
terminal should face the operator . Ensure the
battery is fully seated before proceeding . See
Battery Replacement section for details .
3.
Install instruction label near the indicator
module on the exterior of the enclosure .
Mark the label to indicate where in the circuit
the AVT is installed .
4.
Install the cap label with the appropriate
language, if other than English .
BATTERY FREE INDICATOR MODULE
1.
Tighten the panel nut until both it and the
gasket make full contact with the enclosure
surface . Then, tighten an additional 1/4 turn .
2.
Install instruction label near the indicator
module on the exterior of the enclosure .
Mark the label to indicate where in the circuit
the AVT is installed .
3.
Install the cap label with the appropriate
language, if other than English .
Indicator
Module
Faceplate
Instruction Label
Indicator
Module
Housing
Panel
Nut
Gasket
