AT-OME-MS52W
92
Configuration and Management Interfaces
Lamp cool down timer
Sets the projector lamp cool-down timer, in seconds. This value specifies the time interval that must elapse, after the
display control “off” command is sent, before the display “power on” command can be sent. This feature is used to
prevent the projector from missing a “power on” command while the lamps are cooling. A minimum of 45 seconds
is recommended for projectors. Available values are from 15 to 300 seconds (5 minutes). The default setting is 15
seconds.
Display Warm-Up Timer
Sets the projector lamp warm-up timer, in seconds. During the warm-up interval, the AT-OME-MS52W will not
start the auto power-off timer. This value specifies the time interval that must elapse, after the display control “on”
command is sent, before the display “power off” command can be sent. This feature is used to prevent a “power
off” command from being sent while the lamps are warming up. A minimum of 45 seconds is recommended for
projectors. Available values are 15 to 300 seconds (5 minutes). The default value is 15 seconds.
Auto power off timer
Sets the time interval before the command to power-off the display is sent, when an A/V signal is no longer present.
The default value is 5 minutes. Available values are 15 seconds to 8 hours.
Control Type
Sets the control protocol for the connected display. Click this drop-down to select the control type. Available
settings are
CEC
,
IP
, and
RS-232
. By default, CEC is selected for control of the display. IP and RS-232 can also be
selected. When IP or RS-232 are selected, more fields are available.
Volume / Mute
This option is only available when
Control Type
is set to
RS-232
or
IP
.
