AT-OME-MS52W
91
Configuration and Management Interfaces
Display page
Control
AutoSwitch
Click this box to enable or disable auto-switching. When this box is checked, the AT-OME-MS52W will automatically
switch inputs when the new device is connected. To disable auto-switching, uncheck this box.
Display Control Method
Click this drop-down list to select the method of display control. The following options are available.
*AutoSwitch must be enabled to use these control methods.
Modes
Description
Active Video Presence*
The AT-OME-MS52W will power-off the display if no active source is detected
on the input. Conversely, the display will power-on when an active source is
detected. This applies to either physical source connections or casting. The Auto
Power Off Timer must expire before the power-off command is sent.
Active Video Presence
w/Occupancy Sensor*
Similar to the Active Video Presence mode, except that an occupancy sensor can
also be used with Active Video Presence mode to determine when the power-off or
power-on command is sent.
Occupancy Sensor
The AT-OME-MS52W will power-on/power-off the display based on the state of
the occupancy sensor. The occupancy sensor must be wired to the AT-OME-
MS52W.
Day and Time
The AT-OME-MS52W will power-on/power-off the display based on the assigned
schedule.
Access Point
Display will power-on/power-off based on the presence of a connection/
disconnection from the AT-OME-MS52W Access Point.
Disabled
No display control
