AT-OME-MS52W
12
2
1
3
2
1
3
GND
GND
-
+
Rear View
Rear View
-
+
Installation
Connectors
The AT-OME-MS52W provides an RS-232 port which can be used to control a display connected to the HDMI
output. Atlona recommends controlling the AT-OME-MS52W using IP and reserving the RS-232 port for local display
control.
1.
Use wire strippers to remove a portion of the cable jacket.
2.
Remove at least 3/16” (5 mm) of insulation from each of the wires.
3.
Insert the wires into correct terminal using the included 3-pin captive screw connector.
4.
Attach the 3-pin connector block to the
RS-232
port on the AT-OME-MS52W.
GND
RX
TX
The AT-OME-MS52W provides the ability to output two-channel balanced analog audio on the
AUDIO OUT
port,
using the included 5-pin captive screw connector.
Use wire strippers to remove enough insulation to allow each wire to be securely fastened to each terminal of the
captive screw connector block and connect the wires as shown.
Balanced XLR audio
RS-232
Audio