25
User manual
Wiring description
Base unit connection
Wire 1 (White) (DATA TX) It connects to appropriate additional devices wires (optional).
Wire 2 (Red-black) (OUT-6) (Beeper) A negative output of additional channel with maximum load
capacity 200mA. This output is multipurpose, it can operate in accordance with selected logic.
Wire 3 (Orange-white) (‘CAN1-High’) It connects to appropriate CAN-High wire of the car.
Wire 4 (Yellow-white) (‘CAN2-High’/OUT-2) Factory setting is ‘Open central lock’. A negative
impulse of 0,8 seconds is formed on the wire to open central lock. Logic of the channel’s operation
can be set in the table of system outputs in AlarmStudio. Channel OUT-2 stops operating as an output
when a car code with enabled digital CAN2-bus is chosen.
Wire 5 (Grey) (INP-1/OUT-1) Factory setting is ‘Door switches’. This wire connects to a wire that
becomes grounded when the door opens. This input is multipurpose, it can operate in accordance
with selected logic.
Wire 6 (Green) (INP-4/OUT-4) Factory setting is ‘Control turn indicators’. This wire connects to the
hazard flashers button. This channel is multipurpose, it can operate in accordance with selected logic.
Wire 7 (White-blue) (INP-5) Factory setting is ‘Brake pedal limit switch’. This wire connects to
the brake pedal button where 12V voltage appears when the pedal is pressed (stop lights wire).
Brake pedal signal is one of the system’s security zones. This input is multipurpose, it can operate in
accordance with selected logic.
Wire 8 (Black) (ground) It should be connected to the car body in a grounding spot. This wire
should be connected FIRST during installation.
Wire 9 (Blue) (DATA RX) It connects to appropriate additional devices wires (optional).
Wire 10 (Brown-white) (INP-3) Factory setting is ‘Front hood and trunk limit switch’. This wire
connects to appropriate wire that becomes grounded when the front hood opens. This input is
multipurpose, it can operate in accordance with selected logic.
ENGINE
TEMPERATURE
SENSOR 2 (RHM)
EXTERIOR
AIR TEMPERATURE
SENSOR 1 (RHM)
WARNING!!!
Place radio module unit wires down.
Do not shield zone of built-in aerial (no less than 3 centimeters
from metal surfaces).
Pandora
RHM-06
ANTENNA
2,4 GHz
!
(–)
(+) Fuse 20A
(+) 2A
3..100V min 8Hz
(–)
(–) 200mA
0,1..300V
10A
10A
12
11
10
9
8
7
6
5
4
3
2
1
Black
Red
Blue
White
Blue/White
Green/White
Black
Yellow
Green
Blue/Red
Blue
Blue/Black
GROUND
POWER +12V
SIREN
TACHOMETER SIGNAL
TO FRONT HOOD LOCK • CLOSING
TO FRONT HOOD LOCK • OPENING
PROGRAMMING
RHM • FRONT HOOD TRIGGER
AUX NC BLOCKING
BLOCKING RELAY (COMMON)
BLOCKING RELAY NO
BLOCKING RELAY NC
