35
34
User manual
Pandora DXL-1700L service-security system
Additional devices
Expansion module RMD-8 (see diagram on page 21)
Expansion module RMD-8 is designed to be used in conjunction with Pandora DXL-1700L,
3050L and 5000L service-security systems. RMD-8 allows to significantly expand the capabilities of a
system, provides the ability to connect to the vehicle power circuits (up to 20A) and adds 8 additional
programmable outputs (OUT) and 4 analogue inputs.
RMD-8 is mainly needed to allow remote engine start function via analogue connection when it is
not possible to remotely start engine via CAN-bus.
Module provides control over basic parameters needed for correct and safe operation of the
engine: temperature and engine speed, glow plugs control, state of oil lamp/charge and handbrake/
neutral.
All the necessary information for the software updates can be downloaded from the official company web-
site pandorainfo.com
Name of parameter
Value
Current consumption
no more than 7mA
Supply voltage
9-15V
Operating temperature range
from -40
to +85
o
C
The maximum load current, dial-out
RMD OUT-1 (+)
1А
RMD OUT-2 (+)
1А
RMD OUT-3 (-)
200mА
RMD OUT-4 (-)
200mА
RMD OUT-5 (-)
200mА
RMD K1
20А
RMD K2
20А
RMD K3
20А
Permissible amplitude of tachometer signal
3-300V
Dimensions
45,5х44х17 mm
For Pandora DXL-1700L optionally blocking
RR-102 radio relay is available. Blocking radio
relay with built-in accelerometer should be
placed in the engine compartment. Herewith
zone of built-in aerial 2,4 GHz should not be
shielded.
Provide a rigid fastening to the car body or
to the fixed wirings. It is forbidden to hide the
module in wiring. Radio relay power connects
either from ignition or from a constant power
wire. Radio relay is normally closed, blocking is
carried out only on unauthorized movement.
RR-102 Radio relay connection
Wire 1 and 5 (Black) – Blocking.
These wires should be connected to the circuit in need of blocking. Switching current must be
no more than 10A (for switching circuits without inductive load component). The relay contacts are
normally closed.
Wire 2 (Black) – Programming.
This wire is used to record radio relay to the system’s memory. When recording, the wire connects
to 12V simultaneously with wire 4.
Wire 3 (Black) – Ground.
This wire should be connected to the car body in a grounding spot or to a reliable conductor,
connected to car body or to any grounded device. The wire should be connected FIRST during
installation.
Wire 4 (Black) – Power supply 12V.
This wire should be connected to reliable conductor with constant voltage of 12V or to any wire,
which has constant voltage of 12V when engine is running and this voltage does not disappear when
driving.
1
2
3
4
5
WARNING!
DO NOT PLACE RADIO RELAYS
DIRECTLY ON ENGINE!
Blocking radio relay
