Panasonic Workio DP-C305, Service Manual

Page: 499 / 920

499
DP-C405/C305/C265
FEB 2008 Ver. 1.1
5.1.4. F4 Mode: Input/Output Status Test
Set the machine to Service Mode, and press the “4” key on the Control Panel.
↓
Press the “Start” key to enter the F4 Service Mode on the Control Panel.
↓
Input the code number, and then press the “Start” key on the Control Panel to activate the test.
If you wish to cancel the test, press the “Stop” key on the Control Panel.
↓
Press the “Stop” key on the Control Panel.
↓
Press the “Function” , and the “C (Clear)” keys simultaneously on the Control Panel to exit the Service
Mode.
F4 Mode (Input Check)
No. Function Condition
Message Display
Remarks
7 6 5 4 3 2 1 0
100 Size Sensor X Original detected on the X
position. 1
Size Sensor Y Original detected on the Y
position. 1
Size Sensor Z Original detected on the Z
position. 1
Size Sensor A Original detected on the A
position. 1
Size Sensor B Original detected on the B
position. 1
101 +24V Line Error Detecting
Signal
+24V Line is OFF. 1
Home Position Sensor Home position is detected. 1
ADF/Platen Cover Open
Sensor ADF/Platen Cover is open. 1
ADF/Platen Cover Angle
Sensor ADF/Platen Cover is
open more than 30
°
angle.
1
102 ADF Detection Sensor Unit is not connected. 1
ADF Cover Open Detection
Sensor Cover is open. 1
ADF Paper Exit Detection
Sensor Original is detected. 1
ADF Inverting Detection
Sensor Original is detected. 1
ADF Registration Sensor 3 Original is detected. 1
ADF Registration Sensor 2 Original is detected. 1
ADF Registration Sensor 1 Original is detected. 1
103 ADF Original Length Sensor 2 Sensor is activated. 1
ADF Original Length Sensor 1 Sensor is activated. 1
ADF Original Width Sensor 2 Sensor is activated. 1
ADF Original Width Sensor 1 Sensor is activated. 1
ADF Original Sensor Original is detected. 1
104-
199
Not Used
A
B
Z
Y
X
Platen
Front Side