10
Operating Safeguards
Do not place a magnet near the safety switch of the machine. A magnet can activate the
machine accidentally, resulting in injuries.
Do not use a highly flammable spray, or solvent near the machine. It can cause fire.
When copying a thick document, do not use excessive force to press it against the scanning
glass. The glass may break and cause injuries.
Never touch a labelled area found on, or near the heat roller. You can get burnt. If a sheet of
paper is wrapped around the heat roller, do not try to remove it yourself to avoid injuries or
burns. Switch Off the machine immediately, and wait until it cools down.
Do not use conductive paper, e.g. folding paper, carbon paper and coated paper. When a
paper jam occurs, they can cause a short circuit and fire.
Do not place any heavy object on the machine. An off-balance machine can tip-over, or the
heavy object can fall, causing damage and/or injuries.
Keep the room ventilated when using the machine for an extended period of time to minimize
the ozone density in the air.
When copying with the document cover open, do not look directly at the exposure lamp.
Direct eye exposure can cause eye fatigue or eye injury.
Pull the paper trays out slowly to prevent injuries.
When removing jammed paper, make sure that no pieces of torn paper are left in the machine.
A piece of paper remaining in the machine can cause fire. If a sheet of paper is wrapped
around the heat roller, or when clearing a jammed paper that is difficult or impossible to see,
do not try to remove it by yourself. Doing so can cause injuries or burns. Switch Off the
machine immediately, and wait until it cools down.
Consumable Safeguards
Never heat the drum cartridge, or scratch its surface. A heated, or scratched drum can be
hazardous to your health.
Do not mix new and old batteries together, as they can burst or leak, causing a fire or
injuries. Be sure to use the specified type of batteries only.
.
Ensure that batteries are installed with correct polarity. Incorrectly installed batteries can
burst or leak, resulting in spillage or injuries.
Others
When clearing a paper jam or other fault, follow the appropriate procedure given in this manual.
The machine has a built-in circuit for protection against lightning-induced surge current. If lightning
strikes in your neighborhood, maintain an ample distance from the machine, and do not touch it
until the lightning stops.
If you notice flickering, distorted images, or noises on your audio-visual units, your machine may
be causing radio interference. Switch it Off, and if the interference disappears, the machine is the
cause of the radio interference. Perform the following procedure until the interference is corrected.
Move the machine, and the TV and/or radio away from each other.
Reposition or reorient the machine, and the TV and/or radio.
Unplug the machine, TV and/or radio, and replug them into outlets operating on different circuits.
Reorient the TV and/or radio antennas, and cables until the interference stops. For an outdoor
antenna, ask your local electrician for support.
Use a coaxial cable antenna.
CAUTION
Summary of Contents for Workio DP-C305
