Panasonic VQT1T63, Operating Instructions Manual

Page: 192 / 210

Others
- 192 -
•
Is the [REC]/[PLAYBACK] selector switch at the [
!
] setting? (P36)
•
Is the mode dial correctly set?
•
Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory. (P54)
•
The picture can become whitish if there is dirt e.g. fingerprints on the lens.
> If the lens is dirty, turn on the camera, eject the lens barrel (P11) and gently wipe the lens
surface with a soft dry cloth.
•
Was this picture taken with the flash at the close range when the zoom is near [W] (1 k )?
>
Zoom in a little, and then take the pictures. (P48)
>
Is this a picture taken in [PIN HOLE] in scene mode?
> Check that the exposure is correctly compensated. (P69)
•
Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
> Set the [MIN. SHTR SPEED] to slower speed.
>
Set auto bracket (P70) , multi aspect (P71) , [HI-SPEED BURST] (P91) , [FLASH BURST]
(P91) in scene mode, or the burst mode (P73) to [OFF].
•
The focus range varies depending on the recording mode.
>
Set to the proper mode for the distance to the subject.
•
The subject is beyond the focus range of the camera. (P41)
•
There is camera shake (jitter) or the subject is moving slightly. (P42)
Recording
The picture cannot be recorded.
The recorded picture is whitish.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
2 or 3 pictures are taken at one time.
The subject is not focused properly.