![background image](http://html.mh-extra.com/html/panasonic/toughbook-cf-72-series/toughbook-cf-72-series_reference-manual_264569016.webp)
16
Standby/Hibernation Functions
Resuming Operation
After the display returns, the computer needs a short period of time to reinitialize.
This takes about 30 seconds. Do not shut down or restart Windows, or enter
either the standby or hibernation mode again during this time, as this may
subsequently cause Windows to operate abnormally.
When operation resumes, serial devices such as a mouse, modem or PC
Cards may not function properly. In such cases, you will need to restart your
computer or reinitialize the individual devices.
Avoid the following until the power is completely turned off when turning off
the computer by using the standby or hibernation function, or resuming op-
eration from the standby or hibernation.
• Touch the keyboard (excluding password input), touch pad, touchscreen or
power switch.
• Connect or disconnect the AC adaptor.
• Close the display.
Windows 98
Windows 2000
Even when a password has been set in the Setup Utility,
does not appear
when the computer resumes from the standby or hibernation mode.
(If you want to use the security function when using the standby or hibernation
function, use the Windows password as the following.
Select [Start] - [Settings] - [Control Panel] - [Power Management]* - [Advanced],
then add the check mark for [Prompt for password when computer goes off
standby].)
*
Windows 2000
:[Power Options]
Slide the power switch
Windows 98
Windows 2000
When the computer enters either the standby or hibernation mode by the closing of
the LCD panel, it will resume when the LCD panel is opened. If the computer does
not resume when the LCD panel is opened, slide the power switch.
Windows NT
If the security indicator (
) is displayed, your password has been set.
This password has been set in the Setup Utility and is not a Windows NT password.
CAUTION